3 in 1 feeder  machine has been in a working state and work for a long time may appear some small problems, as people work, do not pay attention to rest, the body will inevitably appear the body bad state, when we are confronted with such a small problem, they can temporary treatment, and don't have to wait for the maintenance personnel to come over, we can solve these problems themselves, of course, is the big problem when it is necessary to wait until the maintenance staff over maintenance. These small problems, Ou Limei Rui senior engineers teach to you some of the most basic self maintenance knowledge.

One, three in one feeding machine troubleshooting.

1, the operation of the material with the next to the deviation, the phenomenon of skew. Treatment method:

(1) to re adjust left and right wheel, a feeding machine in the material belt after the wheel which has entered into the material to a discharge port must be a parallel state.

(2) adjusting the position of the screw, making the average of four points under pressure, at the same time, the pointer must point to the same value, can be adjusted after the adjustment of the positive or flat band, no skew phenomenon.

2, motor function failure, leading to the machine can not run.

(1) check whether the IC circuit board in the electric box falls off, shift or damage, and then drop the shift, please re insert the connection groove. If the test system is damaged, replace the new board.

(2) turn off the power, re boot.

(3) three in one feeding machine to check whether the induction rod is in contact with the material or the state of the body.

Two, the use of three in one feeding machine matters needing attention

1, three in one feeding machine shell must be reliable grounding, so as to avoid leakage wounding and damage the IC board fault.

2, the frequency converter program has been adjusted in the factory, the non professional personnel shall not arbitrarily change the parameters.

3, before connecting the power must be to check whether the power supply voltage to the input voltage consistent, whether the balance of three-phase voltage; otherwise, it is easy to burn out electrical components.

Master more than a few common sense, then you can easily line up the failure of the.