Everyone has a common sense, is any equipment or appliances is the need for the operator to maintenance, for the client to make better use of the equipment and prolong its life, Ou Limei Rui senior engineer to the customer provided several suggestions:

In order to maintain the mechanical properties of the three feeding machine and the safety of machinery, and to take into account the improvement of production skills, please check the following,

1, to the oil, press the machine of the grease gun can be for the roller of the gear and bearing and gear oil.

2, in addition to water; three point combination, press or rotation of the bottom of the water tank under the button, in order to remove the excess water.

The drain valve of the gas tank can be opened, and the water content in the gas storage tank can be removed.

Maintenance inspection

1, timer (timer) is normal

2, remove the foreign body between the roller.

3, whether there is a foreign body between gears.

4, oil pressure pressure is normal, the pressure gauge is normal, and the pressure gauge indicates whether the normal pressure.

5, air pressure gas supply system is leaking.

6, the combination of screws and nuts, whether there is loose.

7, feeding roller is a good parallel (feeding roller in the closure, the upper and lower rollers are all closed).

8, if there is damage, deformation, abnormal noise or other abnormal.

9, switch on the operator panel and display lights are abnormal condition, the man-machine interface may not have foreign body.

Periodic inspection

During the operation, every 6 months or 1000 hours a day in addition to the implementation, inspection items, shall carry out the following checks.

1, the operation panel switch check,

Panel button, contact is whether the guide, whether the oil in the attachment

Can button touch

Timing cam switch check:

Transport and movements have wear

Whether there is oil pollution

Whether the contact part has wear

Control of the relay of the board is good.

Hydraulic machinery piping is good.

2, NC servo system inspection

NC servo system should avoid the dust of Egypt corrosive substances, the ambient temperature should be kept properly, the cooling fan is working properly.

The wire connection of the servo motor is loose, whether the wire will be damaged or not.

3 check list

Car parts

Guide sleeve, guide the need for regular refueling lubrication. (guide sleeve to add butter once every three to two months)

Part 4, material frame

1) check whether the rotation position is flexible, whether the screws are loose. For example: the left and right parts of the material, the supporting material part, the pressure arm part.

2) check the expansion part of the front of the two parts of the nut is loose, 2 weeks to check once, if there is loose, please re lock.

3) check whether all the oil cylinder leakage, once a month.

4) check all cylinders have no air leakage, once a month.

5) need to follow the lubrication chart on time

The 5 part leveling machine

1) drive gear with regular butter, once a month.

2 regularly check whether the head screws loose, timely repair.

3) the head roller should be regularly checked to clean up the debris.

4) need to follow the lubrication chart on time.

5) the head roller should be regularly checked to clean up the debris.

6) leveling machine parts into part of the material feeding detecting device to clean the in each class, to prevent debris, dust and stick in the photoelectric switch material detection apparatus, influence the detection results.

Hydraulic power station

1 regular inspection of the joints are free of oil, two to three months.

2 regular check the fuel tank is enough oil, timely supply, one to three months.

3 regularly check whether the normal operation of the battery valve.

4) regular cleaning of the hydraulic station above the two air cooler, prevent debris, dust and other stained in the air cooler, the effect of the cooling effect of the hydraulic station.

Three color warning lamp:

Green: the normal operation of equipment (inch, inch back, single and automatic mode)

Yellow: feeding part of the standby (inch, inch back, single and automatic mode without action)

Red and make a sound: abnormal equipment / emergency stop.