Triple a send feeding machine is composed of feeding machine, leveling machine, material racks, three in one, saving space, good stability and high precision. It is mainly used for auto parts, metal stamping, electronic digital, elevator parts, caster wheel component such as stamping industry, uncoiling, leveling and feeding of the coil, automatic operation. Three in one feeding machine equipped with automatic detection device, can automatically detect a variety of conditions in the operation, to reduce the rate of defective products play a very good effect, to save a lot of labor costs for enterprises.

Then three in a feeding machine is how to do the automatic feeding of it? The answer to this question by the European real life aesthetic.

1, frame material in the factory set as: when material blocking the induction electric eye frame material stop rotating immediately, when the material left for a period of time (i.e. induction time) frame material began with rotary feeding (the induction process may according to need to design for the opposite).

2, the length of the induction time directly affects the operation and service life of the material rack. The length of the induction time in the electric appliance box panel time to adjust electrical fault and rotating the knob to adjust the required time interval, the length of the induction time to frame material average speed to keep up with the punch required and the motor can not start too frequently for the principle.

 3, combined a feeding machine to start the adjustment: feed start adjustment is by a rotating cam of punch to adjust, so-called send material signal. In other words, to which a punch crankshaft angle began feeding means, at this time of course also decided to punch a rotary feeding time, therefore also send material length is closely related to, the machine to send material perspective standard set for 240~270 connected.

Above a few small common sense to everyone to understand, buy our company's equipment, are free training to learn so far.